Table of Contents
Advertisement
®
S/PDIF & TosLlink
Digital Audio I/O Boards
TosLink Digital Audio I/O Boards Specifications
Applies to I/O board FG1046-455 and to optical connectors on the combination board FG1046-461.
These boards come in a number of pre-engineered systems or can be ordered individually for custom
systems.
Specifications
Resolution
Sample Rate
Output Rise and Fall Time
Jitter
CDR (Reclocking)
Connector
AMX reserves the right to modify its products and their specifications without notice.
Attaching Cables
When attaching digital audio input and output cables, refer to the sheet labeled "AutoPatch Connector
Guide" that ships with the system. The sheet shows you where to attach each cable on the rear
of each enclosure. Follow the sheet exactly; the system was programmed at the factory to operate only as
indicated on the sheet. For multiple-enclosure systems, each enclosure will be numbered (e.g., "Chassis
1 of 3") on a label located on the left side near the power receptacle.
Attaching Digital Audio Cables
Signals may only be routed from the inputs on a board to the outputs on the same board because each board
has its own switching matrix.
To attach S/PDIF digital audio input and output cables:
1.
Insert S/PDIF digital audio (coaxial) plugs into the S/PDIF digital audio jacks (FIG. 49).
Y
Y
C
C
Y
Y
C
C
FIG. 49
Attaching S/PDIF and TosLink digital audio connectors
To attach TosLink digital audio input and output cables:
1.
Remove the protective caps from the TosLink jacks.
2.
Insert TosLink digital audio (optical) plugs into the TosLink digital audio jacks (FIG. 49).
86
16 bit to 24 bit
32 kHz, 44.1 kHz, 48 kHz, 96 kHz
<20 nS
<5 nS
Yes
Optical
Y
Y
Y
Y
C
C
C
C
Y
Y
Y
Y
C
C
C
C
S/PDIF (coaxial) connector
TosLink (optical) connector
Optima Instruction Manual
Advertisement
Table of Contents
Troubleshooting
