Checking The Measurement Status - Adj Mode; Starting Measurement - Run Mode - Omron ZFX-C10 User Manual

Checking the Measurement Status - ADJ Mode

Check whether or not measurement can be performed accurately under the conditions you have set, and
adjust threshold values. Measurement results are only displayed on screen and are not output to external
devices.
ADJ ADJ
MENU MENU RUN RUN
OK Individual result
353ms
0.Bank00
0.Pattern Search
Judge OK
Correlation 92
Position X 462
Position Y 352
Angle 15
Previous Next

Starting Measurement - RUN Mode

When you have checked the measurement conditions you have set, use the RUN mode to perform
measurement. In the RUN mode, measurement results are also output to external devices.
ADJ ADJ
MENU MENU RUN RUN
Important
After you have set the measurement conditions, be sure to save the setup data. All settings will be deleted if you turn
the power OFF without saving the data.
Saving Setup Data p.36
42
Inspection Setup and Measurement
Mode switch
Dsplay SW Adjust
Mode switch
1
Select the ADJ mode.
The results of continuous measurement are displayed on
screen. Make sure that measurement can be performed
accurately and stably.
1
Select the RUN mode.
2
Input the trigger.
Measurement is executed.
Input the trigger using the SET and UP keys.
Note
Switching display content
In the RUN mode, you can switch the display content to
check various information.
Displaying Measurement Information p.102
ZFX-C User's Manual