Omron ZFX-C10 User Manual page 93

Setting Calibration by Specifying Points
With this method, calibration is set by specifying desired points (in pixel units). When the actual coordinates of
a specified position are input, the calibration data is automatically calculated.
When the scale in the X and Y directions is the same
When each of the scales in the X and Y directions are different
Setup method
MENU mode - [Setup] - [Cameras] - [Calibration] - [Specifying point]
Specifying point
Set 2 places.
Set 3 places.
Cameras
Register Position
Item
1st
Apply
X-Axis Y-Axis
80
7 8 9
4 5 6
1 2 3
.
0 +/-
Apply Cancel
ZFX-C User's Manual
Specify 2 locations and input the actual coordinates.
Specify 3 locations and input the actual coordinates.
1
SD
Place the measurement target at the 1st point, and se-
lect either [Set 2 places.] or [Set 3 places.].
Add func
2
( 53, 60)
Move the crosshair cursor to the 1st point, and select
[Apply].
Cancel
3
Input the actual coordinates of the 1st point.
0
AC
BS
Next
91
Cameras/Lighting