Omron ZFX-C10 User Manual page 67

Image adjustment (if necessary)
The following items can be changed and set to the image of the measurement target.
MENU mode - [Setup] - [Item] - [Img Adj]
Item Description
Color filter
Color Pickup/Binary
Which of Color filter or Color Pickup is used can be selected at [Detail] - [Color mode]. The
Filtering
default is use of Color filter.
BGS level
Detailed settings (if necessary)
When measurement is not stable, adjust the detailed conditions. By the automatic setting, the edge search
color is automatically set.
MENU mode - [Setup] - [Item] - [Detail]
Setup Item Setting value
Measurement mode Average (default value)
Maximum
Minimum
Color mode Filter mode
(default value)
Pickup mode
Split size 1 to 99 (default value: 1) Sets the calculation width when the Maximum/Minimum widths are
Light → Dark
Color 1/2
(default value)
Dark → Light
Edge level 1/2 0 to 100
(default value: 50)
Noise level 1/2 0 to 255
(default value: 20)
Noise width 1/2 0 to 255
(default value: 0)
Calibration OFF (default value)
ON
ZFX-C User's Manual
For details, see "Image Adjustment". p.80
Description
Sets the method for calculating the edge width.
Color filter processing improves the contrast of images so that
edges are detected.
Specify the color to measure to find the edge of that color.
to be calculated. The Maximum or Minimum is calculated after the
measurement region is split up by the calculation width to find the
edge(s).
Selects the density change direction of the edge(s) to be
detected.
Sets the level of density change to be judged as an edge.
Sets the level to be judged as noise.
When the difference between the minimum and maximum den-
sity values in the density region is at the noise level or lower, it
is judged that there are no edges. Set a higher value when
noise causes an edge to be detected by mistake.
Sets the width to be judged as noise.
Set a higher value when noise causes an edge to be detected
by mistake.
Measurement results are output using the camera's coordinate values.
Measurement results are output using the coordinate value
converted by the calibration function.
Setting Measurement Items
65