Fun Mode Status Transitions - Omron ZX Series Operation Manual

FUN (Function) Mode
4-5-6

FUN Mode Status Transitions

The status transitions in the FUN mode are shown in the following chart.
Scaling function
For details,
see 4-5-7.
Number of samples
to average
Hysteresis width is normally
changed by direct input.
Automatic hysteresis width setting
Hysteresis
can also be performed by pressing
the ENT Key for 3 seconds.
Hold
Timer mode
2- sensor
operation
Can be selected only
when two Sensors
are connected.
Settings
initialization
Hold down the ENT
Ke y for 3 seconds.
Special
Selected special
Can be selected only
items
for Through-beam
Sensor.
Auto-scale For details, see 4-5-13.
132
4,096 times 128 times
64 times
2,048 times
32 times
1,024 times
16 times
512 times
8 times
256 times
Press the ENT and RIGHT Keys to
move to the timer time setting.
No timer
OFF-delay
ON-delay
One-shot
3 seconds later
Displayed bars light one-by-one from the left.
All of them light after 3 seconds to indicate OK.
No special setting
Settings-related
Displays-related
All displayed
Section 4-5
4 times
2 times
1 time
No hold
Peak hold
Press the ENT and RIGHT
Keys to move to the self-trigger
Bottom hold
level setting.
Sample hold
Self-trigger level
Peak-to-peak
Self-peak
Self-bottom
Numeric values are confirmed
by pressing the UP and
DOWN Keys.
Confirmed by pressing the ENT
Timer time
Key.
setting
Numeric values are confirmed
by pressing the UP and
DOWN Keys.
Confirmed by pressing the ENT
Key.
Timer time can be set only when OFF-delay,
ON-delay, or 1-shot timer is set.
Timer time setting item is added after the
timer mode setting.
No 2-sensor operation
A − B mode
A + B mode
For details, see 4-5-9.
display
For details, see 4-5-11.
Other
For details, see 4-5-12.