Connection; Parallel Connector Specifications - Omron ZFX-C10 User Manual

Connection

Signals such as measurement triggers can be input to the Controller, and signals such as measurement results
can be output from the Controller via its parallel interface. Prepare a parallel I/O cable, and connect it to the
Controller's parallel port for using the parallel interface to input commands and output measurement results.

Parallel Connector Specifications

The Controller has two parallel ports; a standard parallel port and an extended parallel port.
Important
Before the Controller is turned ON, make sure that connectors 0 and 1 are wired correctly. If these connectors
are wired in reverse, the cables or external devices may be damaged.
Parallel I/O Connector 0 (Standard Parallel Port)
Wire the Terminal Block Adapter (supplied) and plug it into the Controller's parallel I/O connector 0.
Pin No.
11 20
1 10
Note
Instead of the Terminal Block Adapter, the parallel I/O cable (ZFX-VP) can be connected to it as well. The wir-
ing of the parallel I/O cable is the same as that of the parallel I/O connector 1.
p.132
130

Connection

Connector 1 (for expansion)
Signal cable
P A R
A L L
E L 1
P A R
A L L
E L 0
Connector 0 (Standard)
Cable diameter: 0.14 to 1 mm
Cable length:
Tightening torque for the respective wire:
Tightening torque for the Terminal Block
Adapter:
Terminal block adapter mounting screws:
2
(AWG26 to 16 twisted lead)
30 m
N•m
0.22 to 0.25
0.3 N•m
M2.6 x 7 screws
(accessories, 4 p'ces)
ZFX-C User's Manual