Omron ZFX-C10 User Manual page 122

Saving during Switching of Bank Groups
Set whether or not to save setup data when a bank group is switched. If saving of setup data is disabled, the
total time taken to switch bank groups can be shortened.
Important
When setup data is changed at the default setting (saving of setup data set to OFF), be sure to manually save the
data before you switch bank groups. Otherwise, the newly changed setup data is cleared.
Saving Setup Data p.36
MENU mode - [System] - [Operation] - [Save at Switch BG]
Setting value
ON
OFF
Password
You can set a password for enabling switching to other modes to prevent erroneous operation.
Note
If you have forgotten your password, you can confirm it by entering the PASSWORD command via the serial interface.
Serial Communication Command Reference
MENU mode - [System] - [Operation] - [Password] - [MENU/ADJ/RUN mode]
Setting value
OFF
ON
MENU mode - [System] - [Operation] - [Password]
Setting value
Password settings
Key Lock in RUN Mode
Menu buttons and operation of the touch panel in the RUN mode can be locked to prevent erroneous
operation. Note, however, that mode switching is not locked.
MENU mode - [System] - [Operation] - [RUN mode key lock]
Setting value
OFF
ON
120
System Settings
Description
Saves setup data when a bank group is switched.
Does not save setup data when a bank group is switched. (default value)
Description
No password is set for moving to other modes. (default value)
A password must be input to switch to other modes.
Description
Sets the password.
Description
The key lock is disabled. (default value)
The key lock is enabled.
ZFX-C User's Manual