Omron SYSMAC CJ - REFERENCE MANUAL 01-2008 Reference Manual page 1093

Network Instructions
Operand Specifications
1054
Unit
Unit connected to network (not
necessary to specify Unit)
Direct specification of the serial
port's unit address
6. The maximum node number depends on the network being used. For a
Controller Link, the allowed range is 00 to 20 hexadecimal (0 to 32). Set
the source node number to 00 to transmit within the local node.
7. Refer to Automatic Allocation of Communications Ports on page 1033 for
details on using automatic allocation of the communications port number
(logical port).
Area
CIO Area
Work Area
Holding Bit Area
Auxiliary Bit Area
Timer Area
Counter Area
DM Area
EM Area without bank
EM Area with bank
Indirect DM/EM
addresses in binary
Indirect DM/EM
addresses in BCD
Constants
Data Registers
Index Registers
Indirect addressing
using Index Registers
Unit address setting
FE hex
Serial Communications Unit ports
Port 1: 80 hex + 4
Port 2: 81 hex + 4
Serial Communications Board ports
Port 1: E4 hex (228 decimal)
Port 2: E5 hex (229 decimal)
CPU Unit ports
Peripheral port: FD hex (253 decimal)
RS-232C port: FC hex (252 decimal)
S
CIO 0000 to CIO 6143
W000 to W511
H000 to H511
A000 to A447 A448 to A959
A448 to A959
T0000 to T4095
C0000 to C4095
D00000 to D32767
E00000 to E32767
En_00000 to En_32767
(n = 0 to C)
@ D00000 to @ D32767
@ E00000 to @ E32767
@ En_00000 to @ En_32767
(n = 0 to C)
*D00000 to *D32767
*E00000 to *E32767
*En_00000 to *En_32767
(n = 0 to C)
---
---
---
,IR0 to ,IR15
–2048 to +2047, IR0 to –2048 to +2047, IR15
DR0 to DR15, IR0 to IR15
,IR0+(++) to ,IR15+(++)
,–(– –)IR0 to, –(– –)IR15
Section 3-25
unit number
unit number
D C
CIO 0000 to
CIO 6139
W000 to W507
H000 to H507
A000 to A443
A448 to A955
T0000 to T4091
C0000 to C4091
D00000 to
D32763
E00000 to
E32763
En_00000 to
En_32763
(n = 0 to C)