Variant A4.P1/A4.P2 (Bks Panic Bar); Product-Specific Safety Instructions - Simons Voss Technologies Digital SmartHandle AX A0 Manual

Digital SmartHandle AX

7.7 Variant A4.P1/A4.P2 (BKS panic bar)

7.7.1 Product-specific safety instructions

IMPORTANT
Damage by drilling
You drill at your own risk. SimonsVoss Technologies GmbH is not liable for damage caused by
drilling.
Please also observe the safety instructions of the drilling machine.

Damage caused by unsuitable tools
If you try to open the case with unsuitable tools, the case may be damaged.
Use only the supplied SimonsVoss opening tool.

Loss of the precise guidance of the handle
It may be difficult to install on mortise locks with a retaining nut.
Do not mechanically alter the locking nut. The handle would then lose its precise guidance.

Difficult installation due to inaccurate holes
The fitting cannot be installed if the fastening holes and the spindle do not match.
Make sure that the fastening holes and the spindle are in parallel vertical lines.

Effect on the mortise lock
The SmartHandle AX acts exclusively on the latch of the mortise lock.
Locking and insurances
Insurance companies place increased demands on a closure.
1. If you want to lock the door under insurance law, use a self-locking panic lock or a locking
cylinder in addition to the SmartHandle AX.
2. Pay attention to the approvals according to EN 179.
(Manual)
NOTE
Sealing escutcheon holes
Any escutcheon holes that exist may be used to manipulate the lock.
1. Seal any escutcheon holes with a blind cylinder, for example.
2. In the case of FH versions, you must be install a brass dummy cylinder or
locking cylinder.
7.. Installation
150 / 296