Sysdrive 3G3Mv Settings; Run Command Selection; Switching Of Run Commands From Devicenet Communications - Omron 3G3MV-PDRT2 User Manual

SYSDRIVE Inverter Settings
4-1

SYSDRIVE 3G3MV Settings

In order to perform DeviceNet communications, it is necessary to make settings for the Inverter
according to the application.
Note The parameters set here are applied to the DeviceNet Communications Unit when the power is
turned ON. Turn OFF the power after changing parameters and turn ON again to apply them.

4-1-1 Run Command Selection

Con- Register
stant number
(hex)
n003 0103 Run com-
mand source
selection
Perform the above setting according to the source of the run commands (forward operation, reverse
operation, STOP) in the application. When run commands (forward operation, reverse operation,
STOP) are always to be made from DeviceNet communications, set to "3."

Switching of Run Commands from DeviceNet Communications

■
There is a switching signal, "Net. Ctrl.," for run commands from the standard remote I/O of the
DeviceNet Communications Unit. The input method for run commands can be changed in the follow-
ing way using the "Net. Ctrl." signal.
Net. Ctrl. = 1 (ON)
Enables run commands from DeviceNet communications (remote I/O run commands become valid)
regardless of the setting in n003.
4-2
Name Content
Selects the run/stop command
input method for the Inverter.
(Becomes valid when the
Remote mode is selected from
Local/Remote.)
0: Run/stop commands from
the Digital Operator are valid.
1: Terminal block (multi-func-
tion input) run commands are
valid.
2: RS-422/485 communica-
tions run commands are valid.
3: Run commands from the
Optional Unit (DeviceNet Com-
munications Unit) are valid.
Note In Local mode, run com-
mands are restricted to
those performed using
the operation keys of the
Digital Operator.
Setting Setting Default
range unit setting
0, 1, 2, 1 0
3
Chapter 4
Write
during
operation
No