Inverter Software Versions - Omron 3G3MV-PDRT2 User Manual

Functions and System Configuration
The 3G3MV-PDRT2 is equipped with a connector for DeviceNet connection rather than a terminal
block. The dimension of the connector that extends below the case must be added.

Inverter Software Versions

■
Supported software versions are listed in the following table.
Model Software version
3G3MV Series, VSP010027 (S0027)
3.7 kW and less and higher
VSP010026 (S0026)
VSP010025 (S0025)
VSP010024 (S0024)
3G3MV Series, VSP010105 (S0105)
5.5 kW and more
VSP010104 (S0104)
3G3RV Series VSF105081 (S5081)
and higher
3G3PV Series VSE102014 (S2014)
VSE102013 (S2013)
3G3FV Series VSG101114 (S1114)
VSG101113 (S1113)
VSG101043 (S1043)
1-10
Release date
June 2003 Supports all functions.
Current trace function and warning torque
detection function use increments of 0.01 A.
June 2002 Supports all functions.
Current trace function and warning torque
June 2001
detection function are use increments of
September 2000
0.1 A for detection and display.
September 2002 Supports all functions.
Current trace function and warning torque
May 2001
detection function are use increments of
0.1 A for detection and display.
November 2001 Supports all functions.
Current trace function and warning torque
detection function are use increments of
0.1 A for detection and display.
July 2002 Supports all functions.
Current trace function and warning torque
March 2001
detection function are use increments of
0.1 A for detection and display.
September 2002 It is not possible to force-switch the com-
mand right from the network. Specifically,
September 2000
even if netref and netctrl (see Chapter 5
September 1998
Remote I/O Functions) are turned ON, the
command right will not be switched to the
network. Use parameters b1-02 and b1-01
to set the command right.
There are no restrictions to other functions.
Chapter 1
Description