Ethernet Settings; Ethernet Communication Settings - Omron V460-H Series Connection Manual

6. Ethernet Settings

This section shows the specifications of the communication parameter settings, variable
names and other information provided in this document.
Note
This document and the project file only cover the operations that you can perform using the
settings and commands described in this section. To use communication settings that are not
described here, you need to modify the project file.

6.1. Ethernet Communication Settings

The settings required to perform Ethernet communications are as follows.
6.1.1. Communications Settings for Setting PC and Code Reader
This document assumes that you use the settings below to set the code reader using a setting
PC.
Parameter name
IP address
Subnet mask
Gateway
* For the use cases in this document, setting the gateway is unnecessary because the devices
are connected within the same segment of the network.
6.1.2. Communication Settings for Ethernet Unit and Code Reader
It is assumed that you use the settings below to connect the Ethernet Unit and the code
scanner.
Parameter name
IP address
Subnet mask
Gateway
Port number
* For the use cases in this document, setting the gateway is unnecessary because the devices
are connected within the same segment of the network.
Setting PC
192.168.188.100
255.255.0.0
Blank (default)
NJ301-1200
(Built-in EtherNet/IP Port)
192.168.188.1
255.255.0.0
---
(set by software part)
6. Ethernet Settings
Code reader
192.168.188.2 (default)
255.255.0.0 (default)
0.0.0.0 (default)
Code reader
192.168.188.2 (default)
255.255.0.0 (default)
0.0.0.0 (default)
2001 (default)
8