Omron 3G3MV-PDRT2 User Manual page 60

Setup and Wiring
2.Wire the main circuit terminals and control circuit terminals of the Inverter. (When the Communi-
cations Unit is mounted, the terminal block of the Inverter will be covered. Therefore, be sure to
complete wiring for the Inverter terminals first.)
3.When the Operator of the Inverter is removed, it will be possible to see a block secured at three
places underneath. Using pliers or another appropriate tool, loosen the fixings, and remove the
block. The connector for Optional Unit connections will become visible. At this point, ensure that
dirt or foreign objects do not enter the connector.
(3) Using pliers, cut sections indicated with "X."
4.Mount the mounting base (included as an accessory) onto the screw-holes originally used for hold-
ing the Operator and the terminal cover to the body of the Inverter, and using the screws provided
as accessories, secure the mounting base.
5.On the opposite side of the DeviceNet Communications Unit, there is a ground terminal that con-
nects to the shield wire for the Communications Cable. Connect this ground terminal to the FG
terminal of the Inverter.
3-8
CN1
CN2
(2) Wire the main circuit terminals
and control circuit terminals.
(4) Mounting base
CN1
CN2
Chapter 3