Table of Contents
Advertisement
2.1.7 Wiring the Digital Input/Output
The 6-contact terminal block connector on the front panel of Industrial Managed Switch is used for Digital Input and Digital
Output. Please follow the steps below to insert wire.
1.
The Industrial Managed Switch offers two DI and DO groups. 1 and 2 are DI groups, 3 and 4 are DO groups, and 5 and 6
are GND (ground).
2.
Tighten the wire-clamp screws for preventing the wires from loosening.
3.
There are two Digital Input groups for you to monitor two different devices. The following topology shows how to wire DI0
and DI1.
Figure 2-8 Wiring the DI and DO
1
2
3
DI0
DI1 DO0 DO1 GND GND
Figure 2-9 6-pin Terminal Block for DI and DO Wiring Input
User's Manual of IGS-6325 series
DI DO
GND
4
5
6
31
Advertisement
Table of Contents
