Ntp Configuration - Planet Networking & Communication IGS-6325 Series User Manual


Privilege Level
Buttons
: Click to apply changes.
: Click to undo any changes made locally and revert to previously saved values.

4.2.1.6 NTP Configuration

Configure NTP on this page. NTP is an acronym for Network Time Protocol, a network protocol for synchronizing the clocks of
computer systems. NTP uses UDP (data grams) as transport layer. You can specify NTP Servers. The NTP Configuration
screen in Figure 4-2-8 appears.
consists of a single module (e.g. LACP, RSTP or QoS), but a few of them contain
more than one. The following description defines these privilege level groups in
details:

System: Contact, Name, Location, Timezone, Log.

Security: Authentication, System Access Management, Port (contains Dot1x
port, MAC based and the MAC Address Limit), ACL, HTTPS, SSH, ARP
Inspection and IP source guard.

IP: Everything except 'ping'.

Port: Everything except 'VeriPHY'.

Diagnostics: 'ping' and 'VeriPHY'.

Maintenance: CLI- System Reboot, System Restore Default, System
Password, Configuration Save, Configuration Load and Firmware Load.
Web- Users, Privilege Levels and everything in Maintenance.

Debug: Only present in CLI.
Every privilege level group has an authorization level for the following sub
groups:

Configuration read-only

Configuration/execute read-write

Status/statistics read-only

Status/statistics read-write (e.g. for clearing of statistics).
User Privilege should be same or greater than the authorization Privilege level to
have the access to that group.
65
User's Manual of IGS-6325 series