Table of Contents
Advertisement
6. TROUBLESHOOTING
This chapter contains information to help you solve issues. If the Industrial Managed Switch is not functioning properly,
make sure the Industrial Managed Switch was set up according to instructions in this manual.
■ The Link LED is not lit.
Solution: Check the cable connection and remove duplex mode of the Industrial Managed Switch.
■ Some stations cannot talk to other stations located on the other port.
Solution: Please check the VLAN settings, trunk settings, or port enabled/disabled status.
■ Performance is bad.
Solution: Check the full duplex status of the Industrial Managed Switch. If the Industrial Managed Switch is set to full
duplex and the partner is set to half duplex, then the performance will be poor. Please also check the in/out rate of the
port.
■ Why the Switch doesn't connect to the network.
Solution:
1.
Check the LNK/ACT LED on the switch.
2.
Try another port on the Switch.
3.
Make sure the cable is installed properly.
4.
Make sure the cable is the right type.
5.
Turn off the power. After a while, turn on power again.
■ 1000BASE-T port link LED is lit, but the traffic is irregular.
Solution: Check that the attached device is not set to dedicate full duplex. Some devices use a physical or software
switch to change duplex modes. Auto-negotiation may not recognize this type of full-duplex setting.
■ Switch does not power up.
Solution:
1.
DC wire or AC power cord is not inserted or faulty.
2.
Check that the DC wire/AC power cord is inserted correctly.
3.
Replace the DC wire/AC power cord if the cord is inserted correctly; check that the DC/AC power source is
working by connecting a different device in place of the switch.
4.
If that device works, refer to the next step.
5.
If that device does not work, check the DC/AC power.
User's Manual of IGS-6325 Series
372
Advertisement
Table of Contents
