Dhcp Mode - Datavideo HS-4000 Instruction Manual

3. Now open the Switcher Image Import/Export software to establish connection with the
switcher.
Tip: You can also modify the switcher's IP address on the
that it matches the network IP range or the IP assigned to your PC. See the
Section for details. This is also the place where you will be able to check or reset your
device IP address. If you need to subnet your network which can be advanced to some,
please consult your IT specialist for assistance if necessary. After changing your network
settings, always reboot your switcher to apply new settings.

DHCP Mode

Dynamic Host Configuration Protocol (DHCP) is a network management protocol used to
automate the process of configuring devices on IP networks. Once configured to DHCP, the
device will be assigned an IP address by a DHCP server upon connection to the network.
Follow the steps below to set the switcher to DHCP:
1. Open the SETUP sub menu on the LCD screen by pressing the SETUP button on the HS-
4000's control panel.
2. Tap the Network tab then turn ON DHCP. Tap the Save button to save the change.
Graphical User Interface
33
such
Network