Table of Contents
Advertisement
To load a still logo, simply select a logo buffer first then browse to a still logo number and
lastly select 'Load'. The selected still logo should be loaded into the selected buffer.
To adjust the logo position, simply change the X and Y values of the respective logo buffer
which can be found at the bottom of the Logo menu.
Selecting "Clear Logo" clears the logo buffer. Selection of "Delete Logo" removes the logo
from the selected memory slot.
Importing Still Logo from the PC
The Switcher Image Import/Export software (SwitcherImageImEx_vx.x.x.msi) allows the
user to import still logos from the PC to a designated memory slot of the switcher. The
software installation package can be downloaded from the product page.
Note: A standard still logo is basically a still picture with an aspect ratio limited to
480x1080.
See
Chapter 4
for installation instructions and network configuration.
How to use
1. Open the Switcher Image Import/Export Program and make sure the Connect Status
shows "Connected" (shows Not Connected if disconnected).
113
Advertisement
Table of Contents
