Table of Contents
Advertisement
Main
Sub
Load Memory
Save Memory
Load Still
Save Still
Grab Still
Delete Still
Load Stinger
Stinger
Settings
Clear Stinger
Delete Stinger Clip Memory
Note: The Stinger transition effect is currently unavailable and will be added in future
firmware upgrades.
Load Logo
Clear Logo
Delete Logo
Logo 1
Logo 2
Load Ani Logo
Delay
Opens a numeric
keypad to enter a
memory location
OK
Opens a numeric
keypad to enter a
memory location
OK
Destination
Still Number
Load Button
Source
Still Number
Save Button
Grab Destination
Grab
Still Number
Delete Button
Clip Memory
Locations
Load Button
Start Frm
Mid Frm
End Frm
Clear
Locations
Delete Button
Logo Destination
Logo Memory
Location
Load Button
Clear
Logo Memory
Location
Delete Button
X
Y
X
Y
Ani Logo Destination
60
Options and Parameters
Range: -60 – 24 (dB) with default = 0 dB
Audio out delay
Range: 0 – 340 ms with default = 0 ms
Memory Selection from 1 to 1000 (Default:
None)
Tap OK to load the memory location entered
Memory Selection from 1 to 1000 (Default:
None)
Tap OK to save to the memory location entered
Input 1 – 8
0 – 999
Tap Load to load from the selected still number
Input 1 – 8
0 – 999
Tap Save to save to the selected still number
Input 1 – 8
Tap Grab to grab the current program view to
the selected destination
0 – 999
Tap Delete to remove the still picture from the
selected still number
0 – 999
Tap Load to load the selected clip
Sets the clip's start and end frames and the
transition frame.
Clear the loaded clip
0 – 999
Tap to remove the selected clip
Logo 1
Logo 2
Memory locations from 0 to 999
Loads the selected logo
Clear the loaded logo
Memory locations from 0 to 999
Remove logo from a memory location
X coordinate from -50 to +50
Y coordinate from -50 to +50
X coordinate from -50 to +50
Y coordinate from -50 to +50
Logo 1
Logo 2
Advertisement
Table of Contents
