Table of Contents
Advertisement
13. TALLY OUT
The HS-4000 Tally Output port provides bi-
colour tally information to a number of
other Datavideo products, such as the ITC-
100 eight channel talkback system or the
Datavideo TLM range of monitors.
See
Appendix 1
and
Section 5.6
for more
details.
14. Ethernet Port
The DVIP port is designed for the user to
access the switcher's settings as well as the
streaming server. You can either use a
static IP address to connect or connect with
DHCP. See
Section 2.2 Network Setup
to
set up your network for accessing the
switcher and
Chapter 9
for streaming
server setup.
Please note that the switcher uses a static
IP address by default which is
192.168.100.101. You can use the reset
hole next to the USB FW Upgrade port to
restore the default IP address. Use a needle
to push the reset hole then hold for about 5
to 10 seconds until the machine reboots
itself to restore the switcher's default IP
address.
15. USB Control Port
Connect the RMC-2 Camera Controller to
the USB control port for remotely operating
the cameras that are on the same network
as the HS-4000.
Note: Refer to the RMC-2's user manual
for instructions on operation of the
camera controller.
General
16. Monitor HDMI IN (External Video
Input)
The HS-4000 provides a useful connection
for confidence monitoring of HDMI sources
on location.
Connect one external HDMI input source
for monitoring the live show.
16
Advertisement
Table of Contents
