Advertisement
Quick Links
Advertisement
Related Manuals for Datavideo DAC-10
Summary of Contents for Datavideo DAC-10
- Page 2 These meters show the audio INPUT level from the incoming source INDICATORS 8. AUDIO INPUT LEVEL Turn these knobs to adjust the Audio OUTPUT level of the DAC-10. CALIBRATION Adjust the audio level controls for each left (channel one) and right (channel 2) to let level LED’s indicating in between yellow (0dB) and...
- Page 3 6 pin DV (FireWire, iLink, IEEE 1394) cable, from the DV port of a camcorder, DV Bank, DV deck, etc. 7. DIP SWITCH MODE SETTING Please refer to next page the DIP Switch setting. 8. BLACK BURST SIGNAL OUTPUT Video Black Burst Signal to be used as a sync reference source 9.
- Page 4 Dip Switch Setting for Mode Select: *. Note1 Mode DIP switch (Reboot the DAC-10 if you change a DIP Switch) S1. PAL or NTSC (PAL-ON, NTSC-OFF) S2. 7.5 IRE / 0 IRE (0 IRE-ON, 7.5 IRE-OFF). (NTSC mode only) *. Note2: 0 IRE is most often used in Japan. 7.5 IRE is used elsewhere.
- Page 5 Dip Switch Setting to work with Windows & MAC Operation system The DAC-10 has dip switches 4 and 5 that control the clocking frequency when it is converting video, if the dip switches are not configured for your operating system or type of device, a loss in video can occur.
-
Page 7: Operation Procedure
Operation Procedure: Step_1. Select the desired mode by setting the dip switches. Reboot the DAC-10 after changing the dip switches Step_2. Install the equipment as shown in installation diagrams Step_3. Ensure that all equipment is turned on Step_4. Select the video source. If the video source is analog, select the desired audio sampling Rate Step_5. -
Page 8: Specification
INPUTS SPECIFICATION S-VHS Video Source Y/C in: 4--pin 75 ohm DIN connector Composite Video Sources 1.0 Vp-p 75 ohm BNC connector Component YUV Video Betacam standard,Y, R-Y, B-y 75 ohm BNC connectors DV (iLink)Source Data Transfer Rate 25Mbps, PAL: 4:2:0 NTSC: 4:1:1 Outputs S-VHS Video Source Y/C out 4-pin 75 ohm DIN connector... -
Page 9: Service And Support
It is our goal to make your products ownership a satisfying experience. Our supporting staff is available to assist you in setting up and operating your system. Please refer to our web site www.datavideo-tek.com for answers to common questions, support requests or contact your local office below. - Page 10 All the trademarks are the properties of their respective owners. Datavideo Technologies Co., Ltd. All rights reserved 2003 P/N: 082060351E2...
Need help?
Do you have a question about the DAC-10 and is the answer not in the manual?
Questions and answers