Burkert 8792 Operating Instructions Manual page 154

Specifying interval for the output of messages
Key Action
/ Select TRAVEL.ACCU
ENTER
Press
* Required for analog position sensor only (setting the STROKE submenu)
/ * Select STROKE
INPUT *
Press
/
*
<
/ Select LIMIT
INPUT
Press
/
<
OK
Press
EXIT Press
Table 87: TRAVEL.ACCU; specifying interval.
CYCLE.COUNTER – Direction reversal counter
The direction reversal counter counts the number of changes in direction of the actuator piston. A change in
direction is detected when the position of the actuator piston changes by at least 1 %.
The interval for outputting messages is specified by inputting a limit for the total number of changes in direction.
• To do this, a history entry is made in the HISTORY submenu. For description see "26.2.22.7. History
entries in the HISTORY submenu".
• The status signal, which is assigned to the message, is indicated at short intervals on the display.
See also D.MSG and CONFIG.MSG in Chapter "26.2.22.5", page 147.
Display CYCLE.COUNTER
CYCLE.COUNTER
LIMIT
NEXT.M
HISTORY
29-7-1
EXIT
Table 88: SERVICE.TIME; operating-hours counter
156
Description
(To do this, the TRAVEL.ACCU function must be incorporated
into the DIAGNOSE main menu. See Chapter "26.2.22.4. Acti-
vation of diagnosis functions").
The menu is displayed.
The preset value is displayed.
Set total stroke of the actuator piston.
Increase value
Changing the decimal
place
The preset value is displayed.
Setting interval for outputting the message (limit for total number
Increase value
of piston movements).
Changing the decimal
place
Return to the TRAVEL.ACCU menu.
Return to the DIAGNOSE main menu.
Description of the functions
The interval for outputting the message can be changed in the LIMIT
submenu. 1 million changes in direction have been preset at the
1000000
factory.
999960
After NEXT.M the remaining changes in direction are displayed until the
next message appears.
INPUT
The history entries of the last 3 messages can be viewed and deleted in
the HISTORY submenu.
english
Type 8792, 8793 Type 8792, 8793
Configuring the auxiliary functions