Burkert 8792 Operating Instructions Manual page 124

• Safepos - Outputting the message: Actuator in safety position
• ERR.SP/CMD - Outputting the message: Sensor break for process set-point value/set-point position
Only available if the function in the SIG.ERR menu has been activated (SIG.ERR → SP/CMD input → Error
on).
See Chapter "26.2.12 SIG.ERROR – Configuration of signal level fault detection".
• ERR.PV - Outputting the message: Sensor break for process actual value (only for Type 8793)
Only available if the function in the SIG.ERR menu has been activated (SIG.ERR → PV Input → Error on).
See Chapter "26.2.12 SIG.ERROR – Configuration of signal level fault detection".
• Remote - Output AUTOMATIC / MANUAL operating state
• Tune.Status - Output TUNE (process optimization)
Key Action
/ Select submenu option
SELEC
Press
Table 61: OUT BIN1 / OUT BIN2; specifying Safepos, ERR.SP/CMD, ERR.PV, Remote or Tune.Status as output.
• DIAG.State-1/2 - Diagnosis output (option)
Outputting the message: Diagnosis message from selected status signal
For description see Chapter "26.2.22 DIAGNOSE – Menu for monitoring valves (option)".
Key Action
/ Select DIAG.State-1/2
SELEC
Press
/ Select status signal
SELEC
Press
EXIT Press
Table 62: OUT.type; inputting switching status for binary output and return to the process level.
126
Description
(Safepos, ERR.SP/CMD, ERR.PV, Remote or Tune.Status).
Acknowledge submenu option as output function for the binary
output. The selection is marked by a filled circle
Then set the required switching status in the OUT.type submenu.
Description
The status signals, which can be activated for outputting the
message, are displayed.
Select the status signal which is to be assigned to the diagnosis
output.
Activate the selection by checking the box
unchecking the box
If required, activate further status signals for the diagnosis
output by pressing the
Acknowledgment and simultaneous return to the OUT BIN 1/2
menu.
Then set the required switching status in the OUT.type
submenu.
english
Type 8792, 8793 Type 8792, 8793
Configuring the auxiliary functions
or deactivate it by
.
/ and keys.
SELEC
.