Connection And Start-Up Of The Remote Sensor Type 8798 - Burkert 8792 Operating Instructions Manual

Type 8792, 8793 Type 8792, 8793
Attachment and assembly
12.4.2

Connection and start-up of the Remote Sensor Type 8798

WARNING!
Risk of injury from improper start-up.
▶ Start-up may be carried out by authorised technicians only and with the appropriate tools.
Risk of injury from unintentional activation of the system and an uncontrolled restart.
▶ Secure system from unintentional activation.
▶ Following assembly, ensure a controlled restart.
→
Connect the 3 or 4 wires of the sensor cable to the designated screw-type terminals of type 8792/8793.
Connection of screw-type terminals: See chapter "15.2.4 Terminal assignment for external position
sensor (for remote model only)", page 59.
Connection of M8 circular connector (only for
→
Attach Remote Sensor on the actuator.
The correct procedure is described in the brief instructions for the Remote Sensor.
→
Connect compressed air to Type 8792/8793.
→
Connect Type 8792/8793 pneumatically to the actuator.
→
Switch on operating voltage to the Type 8792/8793.
→
Run the X.TUNE function.
PROFIBUS): See chapter PROFIBUS "30" .
english
49