Burkert 8792 Operating Instructions Manual page 153

Type 8792, 8793 Type 8792, 8793
Configuring the auxiliary functions
TRAVEL.ACCU – Path accumulator
The path accumulator records and adds up the path which the actuator piston covers. A movement of the
actuator piston is detected when the position changes by at least 1 %.
The interval for outputting messages is specified by inputting a limit for the total number of piston
movements.
• To do this, a history entry is made in the HISTORY submenu. For description see "26.2.22.7. History
entries in the HISTORY submenu".
• The status signal, which is assigned to the message, is indicated at short intervals on the display.
See also D.MSG and CONFIG.MSG in Chapter "26.2.22.5", page 147.
Display TRAVEL.ACCU
TRAVEL.ACCU
20.0 mm
STROKE
LIMIT 1000000 cm
NEXT.M 999954 cm
HISTORY
29-6-1
EXIT
Table 86: TRAVEL.ACCU; path accumulator
Operating structure:
TRAVEL.ACCU ENTER
EXIT
* Input required for analog position sensor only
Fig. 93: Operating structure TRAVEL.ACCU
Description of the functions
The STROKE submenu specifies the total stroke of the actuator piston.
The total stroke is automatically determined during the basic setting of
the device (running X.TUNE).
In the case of an analog position sensor, the total stroke must be input
by pressing the
The interval for outputting the message can be changed in the LIMIT
INPUT
submenu. A piston movement which covers 10 km has been preset at
the factory.
After NEXT.M the remaining piston movement distance is displayed until
the next message appears.
The history entries of the last 3 messages can be viewed and deleted in
the HISTORY submenu.
STROKE
LIMIT
NEXT M.
HISTORY
key.
INPUT
INPUT
Input total
stroke*
INPUT
Input
Limit
Display the remaining distance until the next message
ENTER
History entry
is displayed
OK
ESC
OK
ESC
Delete history entry
CLEAR
EXIT
english
155