Lenovo ThinkSystem SD650-N Manual page 38

Serviceable: Yes
Automatically notify Support: No
Alert Category: Critical - Temperature
SNMP Trap ID: 0
CIM Prefix: PLAT CIM ID: 0524
User Action:
Complete the following steps:
1. Check the event log of system management module and XClarity Controller for any cooling related
issue.
2. Make sure CDU supply water temperature and flow rate per tray is within operating specifications.
3. Make sure waterloop assembly and maifold are installed correctly.
4. Make sure that the room temperature is within operating specifications.
5. If the problem persists, contact Lenovo Support.
• FQXSPCA2007I: Numeric sensor [NumericSensorElementName] going high (upper non-critical)
has deasserted.
This message is for the use case when an implementation has detected an Upper Non-critical sensor
going high has deasserted.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: Warning - Temperature
SNMP Trap ID: 12
CIM Prefix: PLAT CIM ID: 0491
User Action:
Information only; no action is required
• FQXSPCA2009I: Numeric sensor [NumericSensorElementName] going high (upper critical) has
deasserted.
This message is for the use case when an implementation has detected an Upper Critical sensor going
high has deasserted.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: Critical - Temperature
SNMP Trap ID: 0
CIM Prefix: PLAT CIM ID: 0495
User Action:
Information only; no action is required
• FQXSPCA2011I: Numeric sensor [NumericSensorElementName] going high (upper non-
recoverable) has deasserted.
This message is for the use case when an implementation has detected an Upper Non-recoverable sensor
going high has deasserted.
Severity: Info
Serviceable: No
Automatically notify Support: No
34
ThinkSystem SD650-N V3 Neptune DWC Tray and DW612S Neptune DWC Enclosure Messages and Codes Reference