Lenovo ThinkSystem SD650-N Manual page 196

3. If the problem persists, collect Service Data logs, and contact Lenovo Support.
• FQXSFMA0075G: Multi-bit CE occurred on CPU [arg1] high bandwidth memory channel [arg2]
pseudo-channel [arg3], need to restart the system for high bandwidth memory self-healing to
attempt post package repair (PPR).
Severity: Warning
Parameters:
[arg1]: Socket number, 1-based. [arg2]: channel on socket [arg3]: Pseudo channel
User Action:
Complete the following steps:
1. Restart the system to allow for high bandwidth memory self-healing to attempt hard post package
repair (PPR).
2. If the problem persists or if PPR attempt failed, collect Service Data logs.
3. Contact Lenovo Support.
• FQXSFMA0077N: SMBus failure encountered when accessing to the SPD of DIMM [arg1]. [arg2].
Severity: Error
Parameters:
[arg1]: DIMM slot silklabel [arg2]: DIMM identifier consists of S/N, FRU and UDI, e.g. "739E68ED-VC10
FRU 0123456"
User Action:
Complete the following steps:
1. Power off the system and remove A/C power.
2. Reseat the DIMM in the slot specified by the event message.
3. Restore A/C power and power on the system.
4. If the problem persists, collect support log and contact Lenovo Support.
• FQXSFPU0001N: An unsupported processor has been detected.
Severity: Error
User Action:
Complete the following steps:
1. Check Lenovo Support site for a firmware update required for this processor and install that update,
if applicable.
2. If the problem persists, collect Service Data logs and contact Lenovo Support.
Note: The solution for this error may involve a system board replacement. If TPM encryption has
been enabled, back up TPM Encryption Recovery Key.
• FQXSFPU0002N: An invalid processor type has been detected.
Severity: Error
User Action:
Complete the following steps:
1. Verify that the processor is a valid option that is listed as a Server Proven device for this system. If a
non-supported processor is identified, remove that processor or replace with a supported processor.
192
ThinkSystem SD650-N V3 Neptune DWC Tray and DW612S Neptune DWC Enclosure Messages and Codes Reference