Start The Transmitter In Operating Mode With Pin Codes; Start The Transmitter In Operating Mode Using Rfid - Tele Radio TG-T12-20 Installation Instructions Manual

START THE TRANSMITTER IN OPERATING MODE WITH PIN
CODES
1. Make sure that the stop button is pressed.
2. Pull out the stop button.
3. Enter the PIN code by pressing the left joystick:
Press left/right to move between the PIN code digits
Press up/down to step between the digits
4. Press side button 4. Release.
5. WITHIN 3 MINUTES FROM PULLING OUT THE STOP BUTTON:
The receiver(s) that was selected in the last session will be automatically selected. If you want to log on
to the last selected receiver, move to the next step.
If you want to select another receiver, press the left joystick to select the receiver(s) that you want to
operate:
Move left/right to step between the registered receivers
Move up/down to select a receiver
6. Press the start buttons (side button 3 + 4) at the same time.
The buzzer beeps.
7. Release the start buttons.
The buzzer stops beeping. LED 1 + 2 flash (green when the battery capacity is good, red when the
battery capacity is poor).
8. When radio communication has been established, LED 1 + 2 go out.
If radio communication is not established within 25 seconds, the transmitter turns off.
START THE TRANSMITTER IN OPERATING MODE USING RFID
NOTE! The transmitters will only accept RFID tags from Tele Radio AB.
1. Make sure that the stop button is pressed.
2. Pull out the stop button.
LED 1 + 2 flash (green when the battery capacity is good, red when the battery capacity is poor).
3. WITHIN 10 SECONDS: Press the RFID tag against the RFID antenna above the stop button. The
buzzer beeps 2 times to confirm that an RFID tag has been shown. LED 1 light (green when the battery
capacity is good, red when the battery capacity is poor).
4. WITHIN 3 MINUTES FROM PULLING OUT THE STOP BUTTON:
Press a button to select the receiver(s) that you want to operate.
The receiver(s) that was selected in the last session will be automatically selected, which is indicated by
the corresponding LED(s) that light red. If no receiver(s) has been selected, the LEDs for all available
receivers will flash red. If a receiver is selected, the LEDs next to the left and the right start buttons flash
red. If no receiver(s) are selected, only the LED next to the right start button flashes red.
5. Press the start buttons (side button 3 + 4) at the same time.
The buzzer beeps.
- 52 -