Chapter 5: Operating Modes - Tele Radio TG-T12-20 Installation Instructions Manual

CHAPTER 5: OPERATING MODES

SELECT OPERATING MODE
NOTE! These Operating modes are made for base board receivers or receivers with expansion boards
that only contain function relays.
NOTE! Before starting to perform these settings, make sure that the stop relays are deactivated!
NOTE! To select Operating mode 0 or 255, the PC program Settings manager must be used. Contact
your representative for assistance.
1. Press the receiver Function button 4 times.
Function LED 4 flashes orange.
2. Relay LEDs 1-7 light to indicate the selected Operating mode:
Relay LED on
-
1
2
1+2
3
1 +3
2 + 3
1 + 2 + 3
1 + 2 + 3 + 4 + 5 + 6 + 7
3. Press the receiver Select button to switch Operating mode.
4. Press the receiver Function button to step one Operating mode number up at a time.
Example: You know that Operating mode 2 is selected, because relay LED 2 lights. When pressing the
Function button one time, you would go to Operating mode 3. If you want to go to Operating mode 4, you would
press the Function button one more time.
5. Press the receiver Select button to select Operating mode. The receiver exits the LED menu and
restarts.
Chapter 5: OPERATING MODES
Operating Mode
0
1
2
3
4
5
6
7
255
- 59 -