Table of Contents
Advertisement
START THE TRANSMITTER IN OPERATING MODE
1. Make sure that the stop button is pressed.
2. Pull out the stop button.
3. If PIN codes are used for authorization: Go to the next section.
4. WITHIN 3 MINUTES FROM PULLING OUT THE STOP BUTTON:
The receiver(s) that was selected in the last session will be automatically selected. If you want to log into
the last selected receiver, move to the next step.
If you want to select another receiver, press the left joystick to select the receiver(s) that you want to
operate:
Move left/right to step between the registered receivers
Move up/down to select a receiver
5. Press the start buttons (side button 3 + 4) at the same time.
The buzzer beeps.
6. Release the start buttons.
The buzzer stops beeping. LED 1 + 2 flash (green when the battery capacity is good, red when the
battery capacity is poor).
7. When radio communication has been established, LED 1 + 2 go out.
If radio communication is not established within 25 seconds, the transmitter turns off.
- 51 -
Advertisement
Table of Contents
