Turn The Transmitter Off; Login/Logout - Tele Radio TG-T12-20 Installation Instructions Manual

6. Release the start buttons.
The buzzer stops beeping. LED 1 + 2 flash (green when the battery capacity is good, red when the
battery capacity is poor).
7. When radio communication has been established and the RFID tag has been accepted, LED 1 lights
(green when the battery capacity is good, red when the battery capacity is poor).
If radio communication is not established within 25 seconds, the transmitter turns off. If the RFID tag is
not accepted, the display shows an error message.
TURN THE TRANSMITTER OFF
1. Press the stop button. The transmitter turns off. All relays deactivate.

LOGIN/LOGOUT

NOTE! If you need to log out a transmitter that is lost or damaged, it is possible to log out from the
receiver. We do not recommend this way of logging out. Contact your representative for assistance.
NOTE! To be able to control a receiver, the transmitter must be registered in the receiver, and logged
in to the receiver. If another transmitter is already logged in to the receiver, it has to be logged out
before any other transmitter can be logged in. If no transmitter is logged in to a receiver, a registered
transmitter will automatically log in when sending radio signals to the receiver. The transmitter will stay
logged in until it is manually logged out. More than one transmitter can be registered in the receiver, but
only one transmitter can be logged in at a time.
Quick logout
NOTE! When the transmitter has established radio communication with one or more receivers, you
can make a Quick logout from those receivers. Note that the Quick logout will log the transmitter out
from all receivers that are participating in the session.
1. Make sure that the transmitter is started in operating mode.
NOTE! The transmitter must have established a radio session with one or more receivers.
2. Press side button 4. Keep pressed.
3. Press the stop button.
4. Release side button 4.
LED 1 + 2 flash (green when the battery capacity is good, red when the battery capacity is poor).
The display shows [Logging out...] while the process is ongoing.
If logout fails, the display shows [FAILED].
If logout succeeds, the display shows [OK]. The transmitter turns off after logging out.
- 53 -