Replace - Tele Radio TG-T12-20 Installation Instructions Manual

Chapter 4: INSTALLERS GUIDE
3. Press side button 3. Keep pressed
4. Press the stop button.
5. Release side button 3.
6. Go to [Erase].
7. Select by pressing side button 4.
8. Select a receiver. Confirm by pressing side button 4. The display shows [Erasing].
If the erasing fails, the display shows [FAILED].
If the erasing succeeds, the display shows [OK].

REPLACE

WARNING! Do not perform this when the receiver is in a session with another transmitter. The radio
communication may become disturbed or broken.
NOTE! You can replace a registered transmitter with another transmitter without having access to the
receiver.
NOTE! If the transmitter that needs to be replaced is registered in more than one receiver, it will only
be replaced in one receiver at a time. If you want to replace a transmitter in more than one receiver, you
need to perform a replacement for each receiver.
NOTE! If the transmitter already have receivers registered, we recommend that you erase all receivers
from the transmitter before starting the replacement. The receiver will automatically be stored in the
same position as it was stored in the old transmitter. If this position is not available, the replacement will
not take place.
Replace a transmitter with a new transmitter
1. Make sure that the stop button is pressed.
2. Pull out the stop button.
3. Press side button 3. Keep pressed.
4. Press the stop button.
5. Release side button 3.
6. Go to [Replace].
7. Select by pressing side button 4.
8. Enter the serial number/ID code for the transmitter that you want to replace by moving the left
joystick up and down. The serial number/ ID code is found on the label in the battery compartment.
9. Confirm by pressing side button 4.
- 46 -