Connect Modbus; Configuration Settings For Tiger Receiver And Transmitter; Configuration Settings For The Modbus Communication Between D8-2/D8-4 And Tiger Receiver - Tele Radio D8-2 Installation Instructions Manual

Chapter 4: INSTALLERS GUIDE

CONNECT MODBUS

Connect D8-2/D8-4 unit to Tiger MX receiver.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
Connect D8-2/D8-4 unit to Tiger MN/MD receiver.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
Connect multiple D8-2/D8-4 units.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
CONFIGURATION SETTINGS FOR TIGER RECEIVER AND
TRANSMITTER
The receiver can be configured to map, scale, ramp or offset the analogue output signals.
NOTE! The settings are made in the PC program Settings Manager. Contact your representative for
assistance.
CONFIGURATION SETTINGS FOR THE MODBUS
COMMUNICATION BETWEEN D8-2/D8-4 AND TIGER RECEIVER
Configure D8-2/D8-4 Analogue input module:
1. Connect D8-2/D8-4 unit to the PC program Settings Manager.
2. Go to MODBUS_ID and set slave address for the D8-2/D8-4 unit, (e.g. 1).
3. Save the settings.
9 10 11 12 13 14
32 33 34 35 36 37 38 39 40 41 42 43
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
- 9 -