START THE TRANSMITTER IN OPERATING MODE
1. Make sure that the stop button is pressed.
2. Pull out the stop button.
The top LED lights (green when the battery capacity is good, red when the battery capacity is
poor).
3. If PIN codes are used for authorization: Go to the next section.
4. WITHIN 3 MINUTES F ROM PULLING OUT THE STOP BUTTON:
Press a button to select the receiver(s) that you want to operate.
The receiver(s) that was selected in the last session will be automatically selected, which is
indicated by the corresponding LED(s) that light red. If no receiver(s) has been selected, the
LEDs for all available receivers will flash red. If a receiver is selected, the LEDs next to the left
and the right start buttons flash red. If no receiver(s) are selected, only the LED next to the right
start button flashes red.
5. Press both start buttons at the same time.
The buzzer beeps.
6. Release the start buttons.
The buzzer stops beeping. The top LED flashes (green when the battery capacity is good, red
when the battery capacity is poor).
7. When radio communication has been established, the top LED lights (green when the battery
capacity is good, red when the battery capacity is poor).
If r adio communication is not established within 25 seconds, the transmitter turns off.
START THE TRANSMITTER IN OPERATING MODE WITH PIN
CODES
1. Make sure that the stop button is pressed.
2. Pull out the stop button.
The top LED lights (green when the battery capacity is good, red when the battery capacity is
poor).
3. If a PIN code is needed to enter,
TG-TX-MNL8, TG-TX-MNR8: LEDs 1-6 flash red.
TG-TX-MXL12, TG-TX-MXR12: LEDs 1-10 flash red.
WITHIN 3 MINUTES : Enter the PIN code (4 digits) by pressing the buttons according to the
table.
FOR DIGIT:
TG-TX-MNL8, TG-TX-MNR8,
PRESS BUTTON:
TG-TX-MXL12, TG-TX-MXR12,
PRESS BUTTON:
4. WITHIN 3 MINUTES F ROM PULLING OUT THE STOP BUTTON:
1
2
3
4
5
1
2
3
4
5
1
2
3
4
5
- 9 -
6
7
8
9
0
6
-
-
-
-
6
7
8
9
10