Start The Transmitter In Operating Mode With Pin Codes; Start The Transmitter In Operating Mode Using Rfid - Tele Radio TG-TX-MNL6 User Instruction

Tiger g2 industrial radio remote controls
Hide thumbs Also See for TG-TX-MNL6:
Table of Contents

Advertisement

START THE TRANSMITTER IN OPERATING MODE WITH PIN
CODES
 
1. Make sure that the stop button is pressed.
 
2. Pull out the stop button.
The top LED lights (green when the battery capacity is good, red when the battery capacity is 
poor).
 
3. WITHIN 3 MINUTES : Enter the PIN code (4 digits) by pressing the buttons according to the 
table. 
 
FOR DIGIT:
TG-TX-MNL6, PRESS BUTTON: 1
TG-TX-MDL10, PRESS BUTTON: 1
 
4. WITHIN 3 MINUTES   F ROM PULLING OUT THE STOP BUTTON: 
Press a button to select the receiver(s) that you want to operate.
The receiver(s) that was selected in the last session will be automatically selected, which is 
indicated by the corresponding LED(s) that light red. If no receiver(s) has been selected, the 
LEDs for all available receivers will flash red. If a receiver is selected, the LEDs next to the left 
and the right start buttons flash red. If no receiver(s) are selected, only the LED next to the right 
start button flashes red. 
 
5. Press both start buttons at the same time.
The buzzer beeps.
 
6. Release the start buttons.
The buzzer stops beeping. The top LED flashes (green when the battery capacity is good, red 
when the battery capacity is poor).
 
7. When radio communication has been established, the top LED lights (green when the battery 
capacity is good, red when the battery capacity is poor). 
If   r adio communication is not established within 25 seconds, the transmitter turns off. 
 
 
 

START THE TRANSMITTER IN OPERATING MODE USING RFID

 
NOTE! If both an RFID tag and a PIN code are used for authorization, it is possible to use only 
the PIN code, e.g. if you have lost the RFID tag. The transmitter will ask for the RFID tag until 
you have entered the first digit of the PIN code. 
 
NOTE! The transmitters will only accept RFID tags from Tele Radio AB .
 
1. Make sure that the stop button is pressed.
 
2. Pull out the stop button.
The top LED lights (green when the battery capacity is good, red when the battery capacity is 
poor).
 
1
2
3
4
2
3
4
2
3
4
- 10 -
5
6
7
8
9
-
-
-
-
-
5
6
7
8
-
0
-
-

Advertisement

Table of Contents
loading

Table of Contents