Create Pin Codes; Register An Rfid Tag - Tele Radio TG-T12-20 Installation Instructions Manual

10. The display shows [Replacing].
If the replacement fails, the display shows [FAILED].The transmitter turns off.
If the replacement succeeds, the display shows [OK]. The transmitter turns off.
CREATE PIN CODES
NOTE! When you have enabled PIN codes, the transmitter will demand a PIN code to let you start the
transmitter after turning it off. You need to create one or more PIN codes before enabling PIN codes.
NOTE! You can store up to 10 PIN codes in the transmitter.
NOTE! '0000' is not a valid PIN code.
1. Make sure that the stop button is pressed.
2. Pull out the stop button.
3. Press side button 3. Keep pressed.
4. Press the stop button.
5. Release side button 3.
6. Go to [PIN] -->[Enter PIN].
7. Select by pressing side button 4.
8. Select the position in the list where you want the new PIN code to be stored by pressing side
button 4. If the position is already taken, the new PIN code will overwrite the old PIN code.
9. Enter the new PIN code (4 digits) by moving the left joystick:
Move joystick...
one step up
one step down
right
left
10. Confirm by pressing side button 4. The transmitter turns off.
REGISTER AN RFID TAG
NOTE! You can register up to 8 Tele Radio RFID tags in the transmitter.
NOTE! If you register an RFID tag that has already been registered, the RFID tag will be erased from the
previous position and stored in a new position.
NOTE! You can register an RFID tag by overwriting another RFID tag.
Chapter 4: INSTALLERS GUIDE
for...
+1
-1
step to the right
step to the left
- 47 -