Table of Contents
Advertisement
START THE TRANSMITTER IN OPERATING MODE
1. Make sure that the stop button is pressed
2. Twist and pull out the stop button.
The top LED lights (green when the battery capacity is good, red when the battery capacity is poor).
3. If PIN codes are used for authorization: Go to the next section.
4. WITHIN 3 MINUTES FROM PULLING OUT THE STOP BUTTON:
Press a button to select the receiver(s) that you want to operate.
The receiver(s) that was selected in the last session will be automatically selected, which is indicated by
the corresponding LED(s) that light red. If no receiver(s) has been selected, the LEDs for all available
receivers will flash red. If a receiver is selected, the LEDs next to the left and the right start buttons flash
red. If no receiver(s) are selected, only the LED next to the right start button flashes red.
5. Press both start buttons at the same time.
The buzzer beeps.
6. Release the start buttons.
The buzzer stops beeping. The top LED flashes (green when the battery capacity is good, red when the
battery capacity is poor).
7. When radio communication has been established, the top LED lights (green when the battery
capacity is good, red when the battery capacity is poor).
If radio communication is not established within 25 seconds, the transmitter turns off.
- 33 -
Hide quick links:
Advertisement
Table of Contents
