Rear Wheel Suspension - Permobil C400 Service Manual

Rear wheel suspension

Removal
1. Switch off the main power switch on the control
panel.
2. Lift up and chock up the wheelchair chassis
so that the rear wheel suspension is free of
the ground.
3. Remove the rear wheel suspension. It is fitted
with a bolt with two washers, see fig.
4. Pull the rear wheel suspension straight
backwards.
Fitting
1. Check that the axle and the rear wheel
suspension bushings are undamaged. Clean
as necessary to remove dirt and rust. Replace
damaged parts.
2. Lubricate the shaft with a thin coating of
grease (Lubetec Redguard, art. no.1190) or oil.
WARNING
Do not use any type of lubrication in the threaded hole or on
the bolt. Clean as necessary.
3. Fit the rear wheel suspension onto the axle
using hand force only.
4. Fit the two washers on the bolt and secure the
rear wheel suspension.
Use a torque wrench to tighten the bolt to
39 ft-Ibs (53 Nm).
NOTE
Do not use a Pneumatic impact wrench.
WARNING
The bolt must be used once only. Removed bolt is not
allowed to be refitted.
Other types of bolts or washers are not to be used.
Do not use any other type of thread lock.
1 2
Rear wheel suspension.
Pos.
1 Bolt, ISO 4017 M10x25 8.8 Fe/Zn 8 C1/
Locking coat DIN 267-28
2 Washer, 10 Fe/Zn 8 C1 (SRKB 11x35x3)
17
Rear wheel suspension
Description