Software Log Off; Installing And Copying Files To The Hard Disk - Matrox Iris GT with MIL Manual

• Serial number. Specifies a unique serial number for your Matrox Iris GT.
• Sub assembly PCB serial number. Specifies the serial number for your Matrox
Iris GT motherboard (MB) and sensor board (SB).
• Sub assembly PCB production lot number. Specifies the production lot numbers
for your Matrox Iris GT motherboard (MB) and sensor board (SB) when it was
produced.
• Sub assembly production date. Specifies the date on which the different parts
went through production: motherboard (MB) and sensor board (SB).
• FPGA content version. Specifies the number and version of the FPGA's content.

Software log off

With the appropriate applications, you can logoff, or reboot the Matrox Iris GT
using the XPConfig /Shutdown or /Reboot command-line options, respectively.
For more information on XPConfig command-line options, see Appendix H:
XPConfig command-line options.
To turn off your Matrox Iris GT, you must disconnect its power supply.

Installing and copying files to the hard disk

Matrox Iris GT is not equipped with a DVD or floppy disk drive. Therefore, if
you need to copy files from an external source to Matrox Iris GT, you can do one
of the following:
• Access a shared disk drive on the network.
• Connect a USB drive (DVD, thumb or flash disk) directly to the VGA/USB cable.
Alternatively, you can connect a USB hub to the VGA/USB cable. Then connect
a USB drive (DVD, thumb, or flash disk) to one of the USB hub's ports. Using a
USB hub becomes practical if you have multiple USB devices to connect to your
Matrox Iris GT (for example, a keyboard, mouse, and one or more USB storage
devices).
Software log off 45