Table of Contents
Advertisement
Routing an auxiliary output signal from your Matrox Iris GT to
a light controller
You can route an auxiliary output signal from your Matrox Iris GT to the
illuminator trigger input of the light controller (for example, a strobe controller
device). To do so, perform the following:
1. Connect the power and the digital I/O signals of your Matrox Iris GT to the
Matrox breakout board by following the steps in the Powering and connecting to
your Matrox Iris GT section, earlier in this appendix.
2. Connect auxiliary output signal 0 (OUT0) or auxiliary output signal 1 (OUT1)
to the trigger input pin (for example, a TTL In) of your lighting controller. To
source the voltage for the signal, use an external power supply. Connecting to the
lighting controller depends on how the expected voltage is supplied:
Routing Matrox Iris GT output signals
121
Advertisement
Table of Contents
