Input Connector - Matrox Iris GT with MIL Manual

Wire terminal Description
J29/STROBE Controlled-current output, designed to be connected to a LED
lighting device (0-500 mA, intensity controlled using the
internal version of the pulse-train strobe signal, generated with
a pulse width modulator (PMW) and exposure timer 2).
J30/GND Ground for the controlled-current output.
Wire terminal Description
J32/GND Ground.
J33/GND Ground.
J34/IN3 Opto-isolated auxiliary signal 3 (input).
J35/IN2 Opto-isolated auxiliary signal 2 (input).

Input connector

The input connector is a series of 8 wire terminals. They connect to your
third-party devices so that the devices can send auxiliary and trigger signals to your
Matrox Iris GT.
Each input signal should have only one input source. For example, when an input
signal comes from a connected third-party device, it should always be the only
source of input for that signal, and not have to compete with the signal from a
re-routed output signal or a push button.
For information on using the input connector, refer to the Routing input signals
to Matrox Iris GT section, earlier in this appendix.
The pinout for the input connector is as follow.
Open-wire connectors reference
Matrox Iris GT signal sent
CCS
Matrox Iris GT signal
received
*
AUX(USER)_OPTO_IN3
a
AUX(USER)_OPTO_IN2
131
Routed through the
Matrox camera
connector
J12
Routed through the
Matrox camera
connector
J6
J5