Table of Contents
Advertisement
108 Appendix F: The Matrox breakout board
Powering and connecting to your Matrox
Iris GT
To power your Matrox Iris GT and connect its I/O signals to your Matrox
breakout board, perform the following:
1. Connect the gray, red, and yellow-brown wires of the digitial I/O and power cable
to the J15, J16, and J17 wire terminals (connectors) of the Matrox camera
connector, respectively. For information on how to connect a wire to the
wire-terminal, refer to the Connecting an open-wire to a wire-terminal section,
earlier in this appendix.
2. If only powering your Matrox Iris GT, wrap insulating tape around each of the
unused wires of the Matrox Iris GT digital I/O and power cable. Otherwise,
connect them to the appropriate wire terminals of the Matrox camera connector;
for information, see the Matrox camera connector subsection of the Open-wire
connectors reference section, later in this appendix.
3. Connect the digital I/O and power cable to your Matrox Iris GT.
4. Connect the external power supply, included in the Matrox Iris GT starter kit, to
your AC power source.
5. Connect the external power supply to the DC power socket of the power source
connector (J18) on your Matrox breakout board.
Advertisement
Table of Contents
