Routing The Controlled-Current Output From Your Matrox Iris Gt To A Led Lighting Device - Matrox Iris GT with MIL Manual

Routing the controlled-current output from your Matrox Iris GT
to a LED lighting device
You can route the controlled-current output from your Matrox Iris GT to a LED
lighting device through your Matrox breakout board. To do so, perform the
following:
1. Connect the power, controlled-current output, and the digital I/O signals of your
Matrox Iris GT to the Matrox breakout board by following the steps in the
Powering and connecting to your Matrox Iris GT section, earlier in this appendix.
2. Connect an open-wire cable from the positive wire terminal (+) of the LED
lighting device to the STROBE
3. Connect an open-wire cable from the negative wire terminal (-) of the LED
lighting device to the GND/J30 wire terminal of the output connector.
lighting
device
For more information, refer to Powering and controlling a LED lighting device with
controlled-current output section, in Appendix D: Using the I/O signals and
controlled-current output of Matrox Iris GT.
1. The CCS is labeled STROBE on the Matrox breakout board.
1
/J29 wire terminal of the output connector.
LED
+
-
Routing Matrox Iris GT output signals
Matrox breakout board
OUT0
+VDC
OUT1
+VDC
OUT2
+VDC
OUT3
+VDC
CCS
STROBE
GND
GND
Output connector
125
J21
J22
J23
J24
J25
J26
J27
J28
J29
J30