Configuring Your Network - Matrox Iris GT with MIL Manual

28 Chapter 2: Powering and connecting to your Matrox Iris GT

Configuring your network

Corporate-wide networks typically use DHCP servers to assign each connected
device an IP address. If your Matrox Iris GT is still in its factory-configured state,
and your network uses a DHCP server, no configuration is required to use your
Matrox Iris GT on your network that uses DHCP.
Matrox Iris GT
Matrox Iris GT connected to a network
When you connect a Matrox Iris GT to your computer directly, use a static IP
address. If your computer has an IP address starting with 169.254 (a subnet), no
configuration is required.
Matrox Iris GT
Matrox Iris GT connected directly to your computer
If you don't know whether your network uses DHCP, proceed to the Configuring
your Matrox Iris GT to use a static IP address section.