Routing A Signal From A Third Party Device To Your Matrox Iris Gt - Matrox Iris GT with MIL Manual

110 Appendix F: The Matrox breakout board
Power connector
DC Input
+VDC:24V
1A
J18

Routing a signal from a third party device to your Matrox Iris GT

The Matrox breakout board can route an auxiliary input or trigger signal from a
third-party device to your Matrox Iris GT through its input connector. For more
information, refer to the Connecting external devices to input signals section, in
Appendix D: Using the I/O signals and controlled-current output of Matrox Iris GT.
To route an auxiliary input from a third-party device to your Matrox Iris GT
through your Matrox breakout board's input connector, perform the following:
1. Connect the power and the digital I/O signals of your Matrox Iris GT to your
Matrox breakout board by following the steps in the Powering and connecting to
your Matrox Iris GT section, earlier in this appendix.
Note that your Matrox breakout board expects the auxiliary input signal to have
❖
a nominal voltage of 15 to 24 V.
2. If routing the signal to the Matrox Iris GT trigger input signal, connect the TRIG+
wire terminal (J37 on the input connector) to the positive (+) trigger output of
your trigger generator.
Matrox breakout board
J19 J20
J38 TRIG+
J37 TRIG-
J39 In0
J36 In1
J35 In2
J34 In3
J33 GND
J32 GND
Input connector
GND
Third party
device
GND