Available Separately - Matrox Iris GT with MIL Manual

Handling
precautions
• VGA/USB cable with an M12 12-pin (female) connector on one end and a
HD-15 (female) connector and a USB connector on the other end. This cable is
meant to connect your Matrox Iris GT to a display device and a USB device (such
as, a keyboard or mouse).
• Matrox breakout board.
• One C-mount 12 mm lens.
The lens of Matrox Iris GT is a sensitive device. It should never be touched
directly. Always cover the lens if the smart camera is not in use to reduce dust
buildup.
If dust accumulates on the lens, use either a can of compressed air or a lens cloth
to remove the dust.

Available separately

You might have also ordered one or more of the following cables:
• GT-CBL-PWR/3*, an open-wire digital I/O and power cable. On one end is an
M12 17-pin (female) connector. The other end consists of 17 separately-colored
wires. For more details about this cable, refer to the Digital I/O and power connector
subsection of the Matrox Iris GT connectors section, in Appendix B: Technical
Reference. This cable is meant to connect your Matrox Iris GT to your Matrox
breakout board, or to obtain power and to connect with third-party digital I/O
devices.
• GT-CBL-PWRDB25*, a digital I/O and power cable. On one end is an M12
17-pin (female) connector and a DB-25 connector on the other. This cable is
meant to connect your Matrox Iris GT to your Matrox Breakout Box.
• GT-CBL-ETH/5*, a 100/1000 BaseT cable with an M12 8-pin (male) connector
on one end and an RJ-45 registered jack on the other. For more details about this
cable, refer to the 100/1000 BaseT connector subsection of the Matrox Iris GT
connectors section, in Appendix B: Technical Reference. This cable is meant to
connect your Matrox Iris GT to another computer or network device.
Inspecting your Matrox Iris GT with MIL package 13