Output Connector - Matrox Iris GT with MIL Manual

130 Appendix F: The Matrox breakout board
Wire terminal Description
J21/OUT0 Open-collector auxiliary signal 4 (output).
J22/+VDC +VDC supply.
J23/OUT1 Open-collector auxiliary signal 5 (output).
J24/+VDC +VDC supply.
J25/OUT2 Open-collector auxiliary signal 6 (output).
J26/+VDC +VDC supply.
J27/OUT3 Open-collector auxiliary signal 7 (output).
J28/+VDC +VDC supply.

Output connector

The output connector is a series of 10 wire terminals. They connect to your
third-party devices so these devices can receive auxiliary output signals and
controlled-current output (STROBE
Each auxiliary output signal sent to a third-party device requires two wires: one
to carry the signal from your Matrox Iris GT, and one to connect the external
pull-up resistor to +VDC, depending on the third-party device.
For information on using the output connector, refer to the Routing Matrox
Iris GT output signals section, earlier in this appendix.
The pinout for the output connector is as follows:
1. The CCS is labeled STROBE on the Matrox breakout board.
1
), via an open-wire.
Matrox Iris GT signal sent
AUX(STB)_OPENC_OUT4
AUX(STB)_OPENC_OUT5
AUX(USER)_OPENC_OUT6
AUX(USER)_OPENC_OUT7
Routed through the
Matrox camera
connector
J8
J9
J10
J11