Gpio (Digital Input/Output Settings) - JAI GOX-2402M-PGE User Manual

GOX-2402MC-PGE | GOX-3201MC-PGE | GOX-5103MC-PGE | GOX-8901MC-PGE | GOX-12401MC-PGE

GPIO (Digital Input/Output Settings)

Related Setting Items:
The camera can input/output the following signals to and from external input/output connectors.
External Output
Internal Output
These signals can be used as triggers and other necessary signals within the camera or as signals
output from the camera to the system, such as those used for lighting equipment control.
Note: See Recommended Circuit Diagram (Reference Examples)
circuit examples.
Use the DigitalIOControl
check LineMode, LineFormat, and set LineInverter. You can also check the status of each digital I/O
as shown in the table below with LineStatusAll.
LineSelector LineMode
Line2 (Opt
Output
Output1 )
Line5 (Opt In 2) Input
Nand0In1 Input
Nand0In2 Input
Nand1In1 Input
Nand1In2 Input
Timestamp Internal
Reset Connection
For digital output, set the output source signal using LineSource. Set the source signal in the same
way for NAND Logic (Nand0In1, Nand0In2, Nand1In1, NandIn2) and TimestampReset.
DigitalIOControl
Line2 : Opt Out
Line5 : Opt In
to set the digital input/output. Select input or output in LineSelector, you can
LineFormat LineInverter
OptCoupled True/False
False
OptCoupled
(fixed)
InternalSignal True/False
InternalSignal True/False
InternalSignal True/False
InternalSignal True/False
InternalSignal False (fixed)
User Manual (Ver. 1.5) - Main Functions
DC IN / TRIG IN Connector (6-pin round)
DC IN / TRIG IN Connector (6-pin round)
LineStatusAll
bit1
bit4 Invalid (Not Available)
bit12
bit13
bit14
bit15
- 43 -
for recommended external
LineSource
Available (Default =
PulseGenerator0)
Available
(Default = Low)
Available
(Default = Off)
DC IN / TRG
IN connector
DC IN / TRG
IN connector