Alarm-Out; Figure 31 ─ Alarm-Out Settings Setup Screen; Figure 32 ─ Alarm-Out Schedule Setup Screen - Eneo DLR-2004/500V Instruction Manual

Alarm
-Out
Highlight Alarm-Out in the Devices menu and press the
allows you to change the settings and establish a schedule for the alarm output from the DVR.
Figure 31 ─ Alarm-Out Settings setup screen.
Highlight the Schedule tab, and the Alarm-Out Schedule setup screen displays.
Figure 32 ─ Alarm-Out Schedule setup screen.
The Range box allows you to set the time that the alarm schedule will be active in 15-minute
increments from 00:00 to 24:00.
The Mode box allows you to set how the alarm reacts during the scheduled time. When set to On,
the Alarm-Out is active during the scheduled time. When set to Event, the Alarm-Out is only
active when there is an Event during the scheduled time.
The Alarm-Out box allows you to select between Alarm Output and Beep (DVR's internal buzzer).
Configure the port's setting based on the PTZ camera manufacturer's
instructions.
4- & 8-Channel Digital Video Recorder
button. The Alarm-Out screen
The alarm output can be given its title by
highlighting the box under the Title heading and
pressing the button. A virtual keyboard
appears allowing you to enter the title.
Highlighting the box under the Type heading
allows to set the alarm output for NO or NC
(normally open or normally closed).
Highlighting the box beside Dwell Time and
pressing the button allows you to set the
dwell time of the alarm output. Dwell times
range from 5 seconds to 15 minutes.
You can add and edit alarm output schedules
on this screen. Highlight the + and press the
button to add a schedule. Highlighting the
boxes under the Column heading and pressing
the button allows you to edit the
information in those boxes.
The Day box allows you to select the days that
the alarm schedule will be active. The choices
are: Sun, Mon, Tue, Wed, Thu, Fri, Sat, M~F,
Hol and All.
33