Using A Mouse; Figure 62 ─ Mouse Display Menu - Eneo DLR-2004/500V Instruction Manual

User's Manual
Clicking
again, position the mouse pointer at the bottom of the screen. Change the
toolbar location by clicking the empty space on the left side of the toolbar and
drag it to where you want it located on the screen. Use the arrow buttons on
the toolbar to pan or tilt the camera in the direction you want. The other controls
on the toolbar perform as described below:

Using a Mouse

You can use a mouse instead of the front panel buttons to perform many of the DVR functions.
In the Live Monitoring mode or Search mode, moving the mouse pointer to the left edge of the
screen displays the following Mouse Display menu.
Full Screen
Selecting (Full Screen) in the Mouse Display menu and choosing the camera number button
displays the selected camera full screen. It is the same as pressing the individual camera buttons
on the front panel or clicking the left mouse button on a camera image when in one of the multiview
formats (i.e., 2x2, 1+5, 1+7 or 3x3). Clicking the left mouse button on the screen again returns
to the previous display mode.
PIP, 2x2, 1+5, 1+7, 3x3
Selecting , ,
the cameras in the selected multiview screen mode (PIP, 2x2, 1+5, 1+7 or 3x3). Selecting each
display mode is the same as pressing the
on the remote control or scrolling the mouse wheel up and down when in one of the multiview
formats (i.e., 2x2, 1+5, 1+7 or 3x3).
NOTE: The PIP, 1+5, and 1+7 display modes will not be supported in the search mode.
58
on the left side exits the toolbar. If you want to display the toolbar
Zoom In / Out
Iris Open / Close
Figure 62 ─ Mouse Display menu.
, or (PIP, 2x2, 1+5, 1+7 or 3x3) in the Mouse Display menu displays
Focus Near / Far
Set / Load Preset
button on the front panel, the
CAMERA
Full Screen
PIP
2x2
1+5
1+7
3x3
Previous Group
Next Group
OSD
button
LAYOUT